Winny A1 Cordless Above-Ground Pool Cleaner Review: Specs, Pros and Cons
As an Amazon Associate we earn from qualifying purchases. Links on this page are affiliate links.
The Winny A1 (model MFA2, black and orange) is a cordless robot for above-ground pool floors, rated for 130 minutes per charge and up to 1,100 square feet. What sets it apart at its price is the timer: it can run up to 4 scheduled cycles across 7 days without an app, and it parks near the edge when the battery runs low. It suits above-ground owners who want the floor kept clean on a routine; it does not claim to climb walls or scrub the waterline. This look is based on Winny's listing, not on our own pool time.
What stands out
- Up to 4 timed cycles in 7 days
- 130 minutes per charge
- Floors up to 1,100 sq ft
- 180μm mesh plus foam filter layer
- 7.7 lb body
Who it fits
Good fit for
Above-ground pool owners who mostly fight leaves, sand and dirt on the floor and want a robot that runs on a weekly timer.
Who should skip it
Skip it if you need walls or the waterline cleaned, or if your pool floor is larger than about 1,100 sq ft.
Verdict: A light, timer-driven floor robot for above-ground pools.
A1 numbers explained
130 minutes, 1,100 sq ft
One charge is rated for floors up to 1,100 sq ft; measure your floor area before buying.
7-day cycle timer
Set up to 4 cleaning cycles within a week by following the manual, then leave it in the water.
2,140 GPH, dual motors
Pump flow figure for the two-motor suction; it pauses at the wall to boost edge suction.
180μm mesh plus foam
The mesh holds leaves and sand, the textured foam layer catches finer dirt.
3.5 L basket, 7.7 lb
A large basket for a light robot, so lifting it out is easy.
Body and charging
The robot weighs 7.7 pounds per the listing. The spec fields give 15.3 x 17.7 x 12.2 inches, much larger than the 15 x 11 x 6.5 inches listed for the WYBOT A1 with the same feature set, so treat that size as uncertain. There are no cables or hoses, an LED indicator shows status, and a full recharge takes 2.5 hours.
Timer days and cleanup
Charge it, set the cycle timer once following the manual, and put it in the pool. It runs along the floor and pauses briefly at each wall to strengthen suction along the edge. When the battery runs low it parks near the side, where you lift it out, open the 3.5 L basket and rinse the mesh and foam layer; heavy debris means rinsing more often.
Winny A1, WYBOT A1 or Bubot 300P
Choose the Winny A1 if a weekly timer matters and your above-ground floor is within 1,100 sq ft. The WYBOT A1 has a near-identical sheet (130 minutes, 1,100 sq ft, 180μm plus foam) with a 2,280 GPH figure and four modes, which suggests both come from the same maker; pick whichever is in stock at the better price. Choose the BUBLUE Bubot 300P if the lowest price matters more, accepting a 90-minute runtime and a 10.5 lb body.
Check before you buy
- Above-ground pool, floor-only cleaning
- Measured floor within the A1's 1,100 sq ft rating
- Willing to set the timer by the manual
- Foam layer rinsed after leafy runs
The product at a glance
Winny A1 Cordless Above Ground Pool Cleaner
Best for: Above-ground pool floors
- Cleaning Coverage
- Pool floor, edges
- Pool Type
- Above ground
- Battery Runtime
- Up to 130 minutes
- Suction Power
- Up to 2,140 GPH
- Power Source
- Cordless
- Debris Capacity
- 3.5L
View on Amazon: Winny A1 Cordless Above Ground Pool Cleaner Affiliate link
The Winny A1 (MFA2) is a 7.7 lb cordless floor robot for above-ground pools, with 130 minutes per charge, 1,100 sq ft coverage, a 7-day cycle timer and self-parking.
Pros
- Weekly timer without an app
- Light and easy to lift
- Mesh and foam filtration
Cons
- Floor only, no wall climbing
- Size field looks wrong
- No app or remote
Good fit if
- You own an above-ground pool
- You want timed floor cleaning
Skip if
- Your walls need scrubbing
- Your floor is over 1,100 sq ft
Verdict: Simple timed floor cleaning for above-ground pools.
Specifications side by side
| Spec | Winny A1 Cordless Above Ground Pool Cleaner |
|---|---|
| Cleaning Coverage | Pool floor, edges |
| Pool Type | Above ground |
| Battery Runtime | Up to 130 minutes |
| Suction Power | Up to 2,140 GPH |
| Power Source | Cordless |
| Debris Capacity | 3.5L |
| Control Method | 7-Day Cycle Timer |
| Ideal For | Above-Ground Pools |
| Dimensions | 15.3 × 17.7 × 12.2 inches |
| Color | BLACK ORANGE |
| Model | MFA2 |
Frequently asked questions
Does the Winny A1 clean pool walls?
The listing describes floor cleaning with extra suction at the wall edge; wall climbing is not claimed.
How long does it run?
Up to 130 minutes per charge, with a 2.5-hour recharge.
Can it run on a schedule?
Yes, it supports up to 4 scheduled cycles within 7 days, set as described in the manual.
How heavy is the Winny A1?
7.7 pounds, according to the listing.
Is it related to the WYBOT A1?
The two listings share most figures and features, so they appear to be versions of one design.
Featured in
See also
- winny c1 platform cleaning pool robot review
- winny b1 26 os600 bo cordless pool cleaner review
- reriou sat30 pool cleaner review
- winny pool cleaner pool vacuum above ground review
- winny pool cleaner cordless robotic pool cleaner review
- Winny B1 Robotic Pool Cleaner Review: Who It Fits and Who Should Skip It
- Winny OS300 Pro Cordless Robotic Pool Cleaner Review: Specs, Pros and Cons
- Winny H02P-mini Cordless Pool Vacuum Robot for Above Ground Pools Review: Who It Fits and Who Should Skip It
- xenonlab cordless vacuum cleaner review
- inteture cordless vacuum cleaner review
